Following troubleshooting in Service Manual i tried to re Get a feed of this content Use this view in a tile. I switched it to the MXG-B series and that fixed the problem. The control name suggests that the default value should be MXG-B but it was not set to that. Log in to follow, share, and participate in this community.

Uploader: Dot
Date Added: 12 September 2006
File Size: 67.64 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 62424
Price: Free* [*Free Regsitration Required]

Complain wrong Brand wrong Model non readable. The question is how we can use t At the command prompt, type: Hardware setup is the one following: Please help me by sharing example code. For more information on the web server feature, see.

Hello, I want to apply a differential signal input to my rectifier circuit. Results in file1 containing only the marker data. If I’m going to use to signal generator for differenti No matter which programming environment you use to create the waveform data, make sure that the data conforms to the data requirements shown on page Many pages are devoted to explaining byte At the ftp prompt, type: Will UP works with NB.


Keysight | Electronic Measurement Products | Agilent

The output board “installed board information status” is “config error” I am switching Sync on and off to trigger DVM It is easier to keep files associated by varying the extenders.

I put the plugin in another mainframe with the same output: The ultimate fix was that the “Configure RF Output” VI runs a series of checks up front to determine the type of instrument that is connected.

Message 3 of 5. Log in to follow, share, and participate in this community.

Agilent PSG MXG Series Signal Generator

Chp 5 of Programmers Guide, Table offers the command: Generally there are two types:. The VI has a ring constant that allows you to change what the first check is looking for. I am triying labiew set continues frequency range from eg: This tool uses JavaScript and much of it will not work correctly without it enabled.

Is there a SCPI command for this?

Creating waveform data – Agilent Technologies N5183A MXG User Manual

I followed all the instructions provided by the “help” section. Message 1 of 5. Mainframe alone i working.


Message 4 of 5. As i know most of the available measurement equipment are single-ended configuration. The primary fault was that the Labveiw does not support modulation and the configure VI was attempting to send a modulation related command.

I’ve noticed that for an arbitrary pulse period say lwbview or 11usthe phase jumps around for one pul Message 2 of 5. Message 5 of 5.

Most Active Software Boards: You can use various programming environments to create ARB waveform data.